Replacement rubber feet for DJI Mavic PRO #3DPrinting #3DThursday
by Jessie Mae
Empirical shared this project on Youmagine!
Had an unintended sudden deceleration and lost one of the rubber feet in the back of my Mavic Pro. As I attach larger legs there I needed a replacement. However, DJI doesn’t make these available at this point in time outside of repair. So I eyeballed the dimensions as good as I could and printed these in Ninjatek Cheetah that I had around. Little bit softer compared to the originals but this filament is very tough.
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!
Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!
Comments
Post a Comment