Thursday, May 10, 2018

Biased Dice #3DPrinting #3DThursday

from Biased Dice #3DPrinting #3DThursday
by Jessie Mae

Be56d5a94de8f02130505f6c5d014a61 preview featured

KazukiYamamichi shared this project on Thingiverse!

Biased Dice

Due to its inner structure, the center of gravity is not centered.
1 is more likely to be rolled than others.
When printing, 1 should be at the bottom.
The higher the infill percentage is the more eccentric it will be.

See more!


649-1
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!

Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!

No comments:

Post a Comment