EV Charge Cable Garage Door Pass #3DThursday #3DPrinting #adafruit

from EV Charge Cable Garage Door Pass #3DThursday #3DPrinting #adafruit
by Pedro

bobobbybob shares:

If you have an electric vehicle charging station in your garage but want to keep your car outside then you will need to run the charging cable under the garage door. This crushes the charging cable and can damage the casing or cause a short.

This pass will cover the charging cable so that the garage door does not crush it when closed.

There are two versions. One for 240 volt level two charging with a thicker cable. The other version is for 120 volt charging cable which you might want to keep a copy in your trunk with your portable charger.

Works with: Nissan Leaf, Tesla, and all others.

download the files on: https://www.thingiverse.com/thing:3446399


649-1
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!

Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!

Comments