Thursday, August 10, 2017

Raspberry PI 3 Box – Big Passive Cooling #3DPrinting #3DThursday

from Raspberry PI 3 Box – Big Passive Cooling #3DPrinting #3DThursday
by Jessie Mae

C48d2f22b4b7fa414c9efb8bf0de3845 preview featured

Snille shared this project on Thingiverse!

This is a passive cooled (with a costume big 28mm x 28mm x 15mm heat sink) Raspberry PI 3 box with a “Clamp” on the long side. I did not find any box fasten this way and not along the long side. I used (a variation of) this on my “MagicMirror” project: http://ift.tt/2vpLUNT

Note 1: The lid “pushes” on the heat sink (from the top) so it is always pressured down against the small plate, the plate is then pushed against the CPU so the heat transfers better.

Note 2: Remember to put some heat paste on both the CPU and the small plate.

See more!


649-1
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!

Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!

No comments:

Post a Comment