Filament cutter #3DPrinting #3DThursday
by Jessie Mae
JeEk shared this project on Thingiverse!
Yet another filament cutter for 1.75mm filament..
The filament is cut in an angle by sliding the blade forward.
Goal:
Fully printable small filament cutter. No need for springs, screws, washers, nuts or anything else that requires the correct dimensions. The only hardware is a blade from a standard box cutter (with snap-off blade). The snapped part should be 9mm..
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!
Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!
Comments
Post a Comment