Thursday, February 16, 2017

GoPro Time Lapser #3DPrinting #3DThursday

from GoPro Time Lapser #3DPrinting #3DThursday
by Jessie Mae

924443b9c4b29350cde1a5fb95cdadff preview featured

PrintFail shared this incredible print on Thingiverse!

Materials needed:

1) Kitchen Timer – Got an super-cheap Egg Shaped timer.
2) A 608 bearing (or print one)

The reduction ratio is 4:1, so in 1h of time lapse, the came will rotate ~ 90 degrees (take this in mind not focusing the object in the start of the time lapse).

Instructions: Pull the top part of the eggtimer apart. Release the bottom screw and mount the internal mechanism in the base section. Secure with the screw.

See the GoPro Time Lapser in action below!


649-1
Every Thursday is #3dthursday here at Adafruit! The DIY 3D printing community has passion and dedication for making solid objects from digital models. Recently, we have noticed electronics projects integrated with 3D printed enclosures, brackets, and sculptures, so each Thursday we celebrate and highlight these bold pioneers!

Have you considered building a 3D project around an Arduino or other microcontroller? How about printing a bracket to mount your Raspberry Pi to the back of your HD monitor? And don’t forget the countless LED projects that are possible when you are modeling your projects in 3D!

No comments:

Post a Comment